Bandsaw Machine Metal Cutting

Band saw machine metal-roll cutting is a mechanical process, which is carried out by a band saw. The band saw is a closed steel strip with teeth, which moves continuously in a circle stretched on two pulleys. Torque is applied to the leading pulley. The cut results very accurate, due to the uniform distribution of pressure during the processing of metal-roll, Cutting can be done strictly perpendicular to the axis of the equipment or at an angle, but not more than 60 degrees.

This type of cutting can be subjected to rolling engineering steel, high-alloyed steel and stainless steels. Band saw cutting machine is applicable for round bars, pipes and the whole range of steel grades. This cutting method has a low speed, but guarantees a smooth and accurate, unmelted cut without indents, roughness or sagging. The absence of melted and indent edges occurs due to the fact that the metal is not exposed to heat. Band saw metal cutting has a small cutting width iup to 1.5 mm, which saves the metal waste. Metal processing accuracy: 0.1 - 1.5 mm with the geometric accuracy of the cut has a deviation of no more than 0.05 mm. It is possible to cut the long and flat rolled-stock products in piles.

Cutting fluid is used during the cutting process, which protects the saw from wear. For the same reason, the machines have special brushes that clean the strip from chips and dust, which also contributes to a smooth and high-quality cut. The ground teeth of the blade are located on one side of the saw. Saws are being installed, when cutting channels, angles, beams and pipes. The backs of the incisors of the saw are reinforced to minimize the vibration while sawing. When cutting stainless steel, a saw is used with a large space between the cutters and the sharp angle of the sharpened teeth. Saws with larger teeth are used when cutting thick metal. Our professionals are familiar with all these subtleties of work. Thanks to our experience and knowledge, our metal cutters quickly and efficiently cope with any work.

Our company provides cutting with a band saw machine of round bars diameter of 30–350 mm, and beams size of up to 35. We can also sell part of round metal roll products using a band saw. Round bars are sold partially not less than 0.5 m. The diameter of a round bar should be from 80 to 250 mm (320 mm, depending on the warehouse where the round bar is located). There must be a cut metal bar at least two meters from the cut piece in our warehouse.

You can contact our managers to buy this rolled stock from our warehouses, band saw metal cutting of a purchased product can be organized, you can also buy a part of the round bar. Our managers will prompt band saw metal cuttingprice , will help draw up a scheme of cuts, prompt the terms of the service being performed and the branches where such cutting is possible. It is possible to order cutting of prepaid metal-roll at a remote branch and order delivery or transfer of this product to the warehouse closest to the consumer by vehicles of our organization with minimal delivery costs.